BenQ MW727 Manuel d'utilisateur télécharger pdf (Page 64)

Maintenance64

12. Restart the projector.

Do not turn the power on with the lamp cover removed.

Resetting the lamp timer

13. After the startup logo, open the On-Screen Display (OSD) menu. Go to the

SYSTEM SETUP: Advanced > Lamp Settings menu. Press MODE/ENTER.

The Lamp Settings page displays. Highlight Reset lamp timer. A warning

message displays asking if you want to reset the lamp timer. Highlight Yes and press

MODE/ENTER. The lamp time will be reset to '0'.

Do not reset if the lamp is not new or replaced as this could cause damage.

10. Connect the lamp connector properly

and place as drawing before lamp

compartment cover installation back.

• Lamp connector must be installed flush

with the connector base as shown in the

image below. A gap between the lamp

connector and the connector base will

cause damage to the projector. The

following images illustrate correct and

incorrect lamp connector installations.

11. Replace the lamp compartment cover

on the projector and tighten the

captive screw.

No gap Gap

Correct Incorrect

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 75 76

Pas de commentaire

BenQ MW727 Manuel d'utilisateur Page 64