BenQ W703D Manuel d'utilisateur télécharger pdf (Page 25)

Operation 25

English

Operation

Starting up the projector

1. Plug the power cord into the projector and

into a wall socket. Turn on the wall socket

switch (where fitted). Check that the

POWER indicator light on the projector

lights orange after power has been applied.

Please use the original accessories (e.g. power

cable) only with the device to avoid possible

dangers such as electric shock and fire.

2. Press POWER on the projector or

remote control to start the projector

and a start up tone sounds. The PO

WER

indicator light flashes green and stays

green when the projector is on.

The start up procedure takes about 30

econds. In the later stage of start up, a

startup logo is projected.

(If necessary) Rotate the focus ring to

just the image clearness.

To turn off the ring tone, see "Turning off the Power on/off ring tone" on page 44 for details.

If the projector is still hot from previous activity, it will run the cooling fan for approximately 90

seconds before energizing the lamp.

3. To use the OSD menus, please set them to your familiar

language first. See "Personalizing the projector menu

display" on page 45 for details.

4. If you are prompted for a password, press the arrow keys

enter a five digit password. See "Utilizing the

password function" on page 27 for details.

5. Switch all of the connected equipment on.

6. The projector will start to search for input signals. The

urrent input signal being scanned displays in the upper left corner of the screen. If the

projector doesn't detect a valid signal, the message 'No Signal' will continue displaying

until an input signal is found.

You c an a ls o pr e ss SO

URCE on the projector or remote control to select your desired

input signal. See "Switching input signal" on page 30 for details.

If the frequency/resolution of the input signal exceeds the projector's operating range, you will

see the message 'Out of Range' displayed on a blank screen. Please change to an input signal

which is compatible with the projector's resolution or set the input signal to a lower setting.

See "Timing chart" on page 65 for details.

To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turning

if off.

Please select language

Press Enter to confirm, Exit to leave

BenQ W703D.book Page 25 Friday, November 25, 2011 9:49 AM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

BenQ W703D Manuel d'utilisateur Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Projecteurs de données BenQ W703D