BenQ DC E1000 Manuel d'utilisateur télécharger pdf (Page 8)

English

Preparing Your Camera for Use4

2.2 Charging the battery

The battery charge status affects the performance of the camera. To maximize the

performance and life of the battery, it is recommended that you fully charge the battery using

the specified charger set (charger and AC power adapter), and then fully discharge it through

the normal use at least one time. Make sure that the power of the camera is off before

inserting the battery.

1. Insert the battery into the charger as shown

in the illustration.

2. Connect one end of the AC power adapter

to the charger.

3. Connect the other end of the AC power

adapter to a wall outlet.

4. When the battery is being charged, the

charger LED indicator lights up in red.

When the battery is fully charged, it turns

into green.

The length of the charging time depends on the ambient temperature and the status of

the battery.

• The camera must be used with the specified charger set. Damage caused by the use of an

incorrect charger set is not covered under the warranty. Always make sure that the

camera is off before removing the battery.

• The battery may be warm after being charged or used. This is normal and not a

malfunction.

• When using the camera in cold environments, keep the camera and its battery warm by

holding it inside your jacket or other warm protective environment.

2.3 Inserting and removing an SD memory card

The camera is equipped with internal memory,

allowing you to record video clips and capture

images. You can also expand the memory capacity

by using an optional SD (Secure Digital) memory

card to store more files.

1. Always make sure the camera is turned off

before inserting or removing a memory card.

2. Insert an SD memory card in the correct

orientation as shown in the illustration.

3. Close the battery / SD memory card cover.

To remove the SD memory card, make sure the

camera is turned off. Press lightly on the edge

of the memory card and it will eject.

DC_E1000_UM.book Page 4 Friday, September 7, 2007 9:34 AM

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Pas de commentaire

BenQ DC E1000 Manuel d'utilisateur Page 8