BenQ MP720P - XGA DLP Projector Manuel d'utilisateur télécharger pdf (Page 50)

Maintenance44

Replacing the lamp

• To reduce the risk of electrical shock, always turn the projector off and disconnect the

power cord before changing the lamp.

• To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes

before replacing the lamp.

• To reduce the risk of injuries to fingers and damage to internal components, use caution

when removing lamp glass that has shattered into sharp pieces.

• To reduce the risk of injuries to fingers and/or compromising image quality by touching

the lens, do not touch the empty lamp compartment when the lamp is removed.

• This lamp contains mercury. Consult your local hazardous waste regulations to dispose

of this lamp in a proper manner.

1. Turn the power off and disconnect the projector from the wall socket. If the lamp is

hot, avoid burns by waiting for approximately 45 minutes until the lamp has cooled.

2. Turn the projector over. Then loosen the screw

on the lamp cover.

3. Remove the lamp cover from the projector.

Do not turn the power on with the lamp cover removed.

4. Disconnect the lamp connector from the

projector.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 60 61

Pas de commentaire

BenQ MP720P - XGA DLP Projector Manuel d'utilisateur Page 50