BenQ W1070+W Manuel d'utilisateur télécharger pdf (Page 53)

Maintenance

7. As shown in the illustration, lower the new lamp.

8. Tighten the screw that secures the lamp.

9. Ensure the handle is fully laid flat and locked in place.

• Loose screw may cause a bad connection, which could result in

malfunction.

• Do not over tighten the screw.

10. Replace the lamp cover on the projector.

11. Tighten the screw that secures the lamp cover.

• Loose screw may cause a bad connection, which could result in

malfunction.

• Do not over tighten the screw.

12. Connect the power and restart the projector.

13. After the startup logo displays, resetting the lamp timer via the OSD menu.

• Under the Advanced OSD menu, go to System Setup : Advanced > Reset Lamp Timer, and

select Reset.

• Under the Basic OSD menu, if there’s no signal connected to the projector, go to Reset Lamp

Timer and select Reset; if there are signals connected, go to Settings > Reset Lamp Timer,

and select Reset.

Do not reset if the lamp is not new or replaced as this could cause damage.

A "Reset Successfully" message displays to notify that the lamp time has been reset to "0".

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 62 63

Pas de commentaire

BenQ W1070+W Manuel d'utilisateur Page 53